EN - SmartDrive MX2+ User’s Manual 9
To turn power assist ON with SwitchControl [take out of the standby state], press [with the 0.9 lbs (4 N) minimal needed force]
for longer than [0.5] seconds, and release one of the buttons. Indication of power assist ON via SwitchControl will be given on
the button LED(s).
To turn power assist OFF with SpeedControl [put it in the standby state], press and release the dial.
To turn power assist OFF with SwitchControl [put it in the standby state], press and release one of the buttons.
[If you have a PushTracker / E3] To turn power assist ON with the PushTracker / E3, press and release the Power Assist
button. Indication of power assist ON via PushTracker / E3 will be given on both the SpeedControl / SwitchControl LED(s) and
PushTracker / E3 [refer to the separate PushTracker / E3 User’s Manual provided].
To turn power assist OFF with the PushTracker / E3, press and release the Power Assist button. Indication of power assist OFF
via PushTracker / E3 will be given on both the SpeedControl / SwitchControl LED(s) and PushTracker / E3.
The SpeedControl / SwitchControl LED(s) give special indication for each of these power assist ON states, as well has having
no flashing for power assist OFF.
With the power assist OFF, or in the standby state, the SmartDrive will not be able to be activated to provide power assist, so
you are able to push the wheelchair around with no power assist.
EZ-ON Power Assist Ready
[on PushTracker only / not on PushTracker E3]
With EZ-ON activated [see “SmartDrive Settings” in the PushTracker User’s Manual], hold your arm so the PushTracker is completely
horizontal [parallel to the ground]. When oriented correctly, the charging LED will illuminate blue [see graphics below], at which point,
DOUBLE tapping down on the PushTracker screen will turn power assist ON. Repeat these actions in order to turn power assist OFF.
This is a great feature if you have limited finger function that makes pressing the Power Assist Button difficult.
Wired Control Deactivation
[using SpeedControl / SwitchControl to deactivate Power Assist]
A SpeedControl / SwitchControl button press and release will ALWAYS deactivate the motor / power assist any time that the
motor is activated and driving. This is even if it is in the PushTracker / E3 power assist ON only state [see “Power Assist Ready”
section].
Note that the device will still be in a state of power assist ready after a SpeedControl / SwitchControl button press
deactivation, and it must be put in power assist OFF / standby state if you do not want the motor to be activated.
To Next Page
Loading...
