EasyManua.ls Logo

Perry Electric TE541 - Technical Data

Perry Electric TE541
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Reference regulations for CE markings:
230V~ +/- 10% 50Hz
class A
4 kV
1,5 mm ÷ 2,5 mm
22
class II
I30P
2
n° 2 « = CONFORT», « = ECONOMY» +t1 t2 OFF antifreeze/thermal protection
045°C + °C÷
+ ON ( ) o + ON (Winter Summer)
0.1 °C
+4 °C ÷ +37.7 °C ( with Max and Min temperature blocks)
limitable
a step di 0.1 °C
adjustable from + 4 °C to t2 (default 5 °C)
max 1°K / 15 min
± °C1
0 °C ÷ +45 °C
-10 °C ÷ +60 °C
LVD - EMC EN60730-2-9EN60730-1
Yes
ErP: Class I; 1% Reg. EU 811/2013
(recessed wall-mounted with wall plate)
adjustable from
-6.0 °C to +6.0 °C (default 0.0 °C)
adjustable from t2 included to +37,7 °C (default «disabled»)
Winter
heating (default) / Summer cooling
Type of installation:
Type of use:
civil and tertiary sectors
Built-in
4
Power supply:
Display and key back-lighting:
Type of action, disconnection and device:
Type of output:
:Number of temperature levels
:Ambient temperature display range
:Relay ON signal
:Room temperature indicator resolution
:Temperature Set adjustment range
Setting temperature Set:
separated by seasons:Temperature correction (Offset)
Antifreeze Tset temperature OFF (Winter):
Thermal protection Tset temperature OFF (Summer):
Keeping memory setting during power failure:
Type of temperature adjustment:
- (default)Proportional with control period
- DIFFERENTIAL ON/OFF
Thermal gradient:
Temperature reading tolerance:
:Operating temperature limits:
Storing temperature limits:
Software:
Rated impulse voltage:
Cross-section of wires to terminals:
Contact input for remote thermostat deactivation:
Type of insulation:
:Degree of protection
:Pollution rating
Operating mode:
ErP energy classification:
1 - TECHNICAL DATA
timed 6 secs. / always on / always off / brightness reduction after 6 sec.
1 B / Electronic
voltage free relay with COM / NO / NC changeover contact,
max 5(3)A/250 V ~
for contact free from potential, minimum insulation 250V~, maximum cable length 15 m.
adjustable from 0.2 °C to 1.2 °C (default 0,3 °C)
cycles adjustable from 7 to 20 minutes (default minutes)7

Other manuals for Perry Electric TE541