Every 120,000 mi / 192,000 km / Annually
15
Drive Axle (Dana) - Air Shift Unit
• Remove the housing cover and drain the lubricant. Wash the parts thoroughly and dry in air. (Refer to Drive Axle - Dana on
page 262 for maintenance instructions.)
Drive Axle (Dana) - Breather
• Clean or replace. (Refer to Drive Axle - Dana on page 262 for maintenance instructions.)
Drive Axle (Dana) - Lube Pump (ON HIGHWAY)
• Remove the magnetic strainer and inspect for wear particles. Wash in solvent and dry in air. (Refer to Drive Axle - Dana on
page 262 for maintenance instructions.)
Drive Axle (Dana) - Lube Filter (ON HIGHWAY)
• Change. (Refer to Drive Axle - Dana on page 262 for maintenance instructions.)
Drive Axle (Dana) - Magnetic Drain Plug and Breather (ON HIGHWAY)
• Clean or replace. (Refer to Drive Axle - Dana on page 262 for maintenance instructions.)
Drive Axle (Meritor Line Haul / ON HIGHWAY) - Lubricant Filter
• Change the filter. (Refer to Drive Axle - Meritor on page 262 for maintenance instructions.)
Drive Axle (Meritor Line Haul / ON HIGHWAY) - Input Shaft and Pinion Shaft
• Check and adjust the endplay. (Refer to Drive Axle - Meritor on page 262 for maintenance instructions.)
Drive Axle (Meritor Line Haul / ON HIGHWAY) - Axle Shaft
• Tighten the rear axle flange nuts to the specified torque value. (Refer to Drive Axle - Meritor on page 262 for maintenance
instructions.)
15
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
those listed here.
MAINTENANCE - Every 120,000 mi / 192,000 km / Annually
202 Y53-6076-1D1 (09/20)
5
To Next Page
Loading...
