instructions very closely. It is vitally
important that all components be
reinstalled in the same position as the
original components that were removed
and that the fasteners be torqued to
specification. This will maintain the design
integrity of the mounting points for the seat
belt assembly. Contact your dealer if you
have any questions concerning seat belt
replacement.
Windshield Wiper/Washer
The windshield wiper system is designed
to be maintenance-free. Check wiper
blades annually, every 60,000 miles
(96,000 km), or when they begin to show
signs of wear.
CAUTION
DO NOT use antifreeze or engine
coolant in the windshield washer res-
ervoir, damage to seals and other
components will result.
Washer Reservoir
Daily: Check reservoir water level, located
in the engine compartment. If necessary,
refill to the proper level.
How to Refill the Washer Fluid
Reservoir
1. Park the vehicle and apply the
parking brakes
2. Open the hood and secure it in the
open position
3. Locate the washer fluid reservoir
and open the filler cap. It will be
located in one of two places:
1. Passenger side (RH) in front of
the steer tire - 2.4 Gallons (9
Liters) capacity
2. Drivers side (LH) on top of the
radiator - 2.0 Gallons (7.6
Liters) capacity
4. Fill the reservoir with windshield
washer fluid and replace the cap
5. Close and secure the hood
Electrical System
WARNING
Battery posts, terminals and related
accessories contain lead and lead
compounds, chemicals known to the
State of California to cause cancer and
reproductive harm. Wash hands after
handling.
WARNING
Before attempting any work on the bat-
teries or electrical system, remove all
jewelry. If metal jewelry or other metal
comes in contact with electrical cir-
cuits, a short circuit may occur causing
you to be injured, as well as electrical
system failure and damage.
MAINTENANCE - Windshield Wiper/Washer
Y53-6076-1D1 (09/20) 233
5
To Next Page
Loading...
