Peterbilt 365 - Where Are the Fuses Located

3. Remove that fuse and see if it is
blown.
1 Blown
Fuse Puller
If it is blown, replace it with a fuse of the
same rating. If a fuse of the same rating is
not available, a fuse of a lower rating may
be temporarily substituted. You can also
use a fuse from a circuit you can do
temporarily without (for example an
accessory circuit or radio).
CAUTION
When replacing a failed circuit breaker,
always use an approved circuit break-
er with a current rating equal to or less
than the circuit breaker being re-
placed. Only use the approved Type II
modified reset circuit breakers. NEV-
ER use a Type I (automatic reset) or
Type III (manual reset) circuit breaker.
A fuse with a current rating equal to or
less than the circuit breaker being re-
placed can also be used.
CAUTION
Always close and latch the engine
compartment fuse box cover. A latch-
ed cover ensures a water tight seal
which can prevent damage to electri-
cal components.
Where are the Fuses
Located?
Fuses for the cab are located in the fuse
panel behind the drivers side kick panel.
Main power relays are located on the
power distribution center mounted to the
front wall of the cab.
EMERGENCY - Where are the Fuses Located?
Y53-6076-1D1 (09/20) 37
2