Petsafe SmartDoor - INSTALL; Determine Pet Door Location; Preparing Door

www.petsafe.net 11
FR ITNL DEEN ES
.
INSTALL
STEP 1
Installing Your Pet Door
Determine Pet Door Location
Measure and mark your pet’s shoulder height on the door
(Fig. 1A).
Determine location for the pet door. Draw a vertical
centre line through the shoulder height line using a level
(Fig. 1B).
If homeowner’s door or other application
is not level, the pet door must be marked
level to swing properly.
Helpful Tip: Mark shoulder height and vertical centre
line lightly with a pencil or on a piece of tape so marks
can easily be erased or removed.
STEP 2
Preparing Door
Match the marked lines on the door with the shoulder
and centre lines on the template. Tape the template in
place and carefully trace cutting template. Make sure to
trace underneath tape and connect the corners. Remove
the cutting template and any excess tape from the door
(Fig. 2A).
When applying the template there should
be a minimum of 7.6 cm between the
bottom and sides of the door and the
outer edge of the template to maintain the
structural integrity of the door.
Fig. 1A
Fig. 1B
Fig. 2A