Care and maintenance
10 - 1
10 Care and maintenance
10.01 Cleaning and maintenance intervals
Clean the hook compartment .................... daily, several times if in continuous operation
Lubricate the hook .................................................................................. daily, before use
Clean the hook .............................................................................................. once a week
Lubricate the post........................................................................................ twice a week
Grease the bevel gears .....................................................................................every year
These maintenance intervals are calculated for the average running time of a
single shift operation. If the machine is operated for a longer period, shorter
intervals are recommended.
10.02 Cleaning the hook compartment and the hook
Turn the machine off!
Danger of injury if the machine
is started accidentally!
● Clean the hook compartment daily with a
brush, several times if in continuous
operation.
● Clean the hook thoroughly once a week.
● Open the post cover.
● Raise the needle bar as far as possible.
● Raise latch 1 and remove the bobbin.
● Unscrew hook jib 2
and remove the bob-
bin case 3.
● Clean the hook race with paraffin.
● Insert the bobbin case 3, ensuring that
horn of the bobbin case fits into the
groove of the needle plate.
● Screw hook jib 2 back on.
● Insert the bobbin and close the latch 1.
● Close the post cover.
Fig. 10 - 01
2
1
3