Adjustment
58
11.08 Error messages and description
Error Description
E 001 System error
E 002 Sewing motor E002/BB/xxx
BB = 20: Deadman
01: Switch on speed
02: Positioning
03: Start distance
04: Read distance
05: Set translation
06: Read translation
07: Error reset
08 Write parameters
09: Read version
0A: Read speed
0B: Read actual position
0C: Delete distance
xxx = Sewing motor controller error byte (see motor error)
E 003 Seam zone data
E 004 Flash memory
E 005 No room on the heap
E 006 Mains voltage outside the work area
E 007 24V IO power supply E007/xx
xx= 1: Short circuit
2: overload
3: 5V timeout when switching on
4: 20 V timeout when switching on
E 008 60V SM power supply E008/xx
xx= 1: Short circuit
2: overload
3: 20V timeout when switching on
4: 50 V timeout when switching on
5: 60 V not reached after switching on
E 009 Encoder of the sewing drive not plugged in
E 017 Serial interface E017/xx
xx= 4: dead man expired
5: Number of communication attempts exceeded
6: Lost USB connection
E 019 Sewing motor has no 180 ° track
E 020 CAN interface E020/xx
xx= 1: Number of CAN nodes wrong
2: Hardware error (possibly short circuit)
3: Communication
E 021 Button pressed when switching on
E 022 Pedal activated when machine turned on
To Next Page
Loading...
