Pfaff 2481-3/01-980/30 - Seam zone settings example

Input
51
O Place the workpiece on the angle outline on the display and adjust the angle.
The correction value is calculated automatically from the adjusted angle.
O Conclude the input and take over the correction value.
O Switch on the automatic sewing stop at the end of the seam zone function.
3
0
2.0
0.0
0
3.0
3.0
1
1.9
3.0
135
1.9
3.0
135
O Seam zone 0
All values entered in this seam zone are valid for all other seam zones in the
seam program, unless they are altered in the individual seam zones.
O Call up the stitch length input menu and enter the stitch length "2.2", see chapter 9.06
Entering the stitch length.
O Call up the menu for entering the edge guide position and enter the edge guide position
"3.0", see chapter 9.07 Entering the edge guide position.
O Call up the seam depth input menu and enter the seam depth "3.0".
O Select the seam zone one.
O Call up the correction value input menu.