Pfaff 2481-3/01-980/30 - Page 52

Input
52
O Select the seam zone two.
O Call up the correction value input menu.
O Place the workpiece on the angle outline on the display and adjust the angle.
The correction value is calculated automatically from the adjusted angle.
O Conclude the input and take over the correction value.
O Switch on the automatic sewing stop at the end of the seam zone function.
O Select the seam zone three.
O Call up the correction value input menu.
O Place the workpiece on the angle outline on the display and adjust the angle.
The correction value is calculated automatically from the adjusted angle.
O Conclude the input and take over the correction value.
O Switch on the automatic sewing stop at the end of the seam zone function.
O Select the seam zone four.
O Call up the correction value input menu.
O Place the workpiece on the angle outline on the display and adjust the angle.
The correction value is calculated automatically from the adjusted angle.
O Conclude the input and take over the correction value.
O Switch on the automatic sewing stop at the end of the seam zone function.
2
3
4