Pfaff 2481-3/01-980/30 - Page 58

Input
58
6 604 Cutting: C OFF - ON ON
ON = forwards after semi end backtack
OFF = in reverse too
605 Speed display: B OFF - ON OFF
ON = on / OFF = off
606 Speed level 1 (min.) [min
-1
] B 30 - 550 180
607 Speed level 12 (max.) [min
-1
] B 300 - 5000 4500
609 Cutting speed [min
-1
] B 60 - 500 180
618 Reverse turning angle B OFF - ON OFF
ON = on / OFF = off
624 Start inhibitor: ON = on / OFF = off C OFF - ON ON
642 Presser foot time from switch-on C 10 - 50 50
to tension reduction (timing)
651 Automatic lowering of presser foot: C OFF - ON ON
ON = on / OFF = off
660 Bobbin thread monitor: A 0 - 2 1
0 = off, 1 = on
2 = bobbin thread reverse counter on
668 Thread wiper = 1, B 0 - 2 2
Thread clamp = 2, 0 = off
7 700 Logical zero mark [increments] B 0 - 127 0
702 Needle position (needle lowered) B 0 - 30 15
703 Needle position (take-up lever raised) B 100 - 127 113
705 Needle position (end of cutting signal) B 80 - 127 98
706 Needle position (start of cutting signal) B 40 - 80 68
707 Needle position B 40 - 80 70
(start thread tension release)
710 Needle position B 80 - 127 106
(needle raised without cutting)
715 Operating time of thread wiper [ms] B 0 - 2550 120
718 Moment of B 0 - 100 0
standstill brake (rest brake)
Group Parameter Setting range Set value User level Description