Input
66
ERROR: 13 OTE header invalid
ERROR: 14 OTE user data invalid
ERROR: 30(#) (OTE error see cap. 11.11)
ERROR: 31(#) (Error Sewing motor see cap. 11.10)
ERROR: 50 Incorrect control panel
ERROR: 51 Incorrect machine class in OTE
ERROR: 52 Incorrect software for main drive
ERROR: 101 Mains voltage
ERROR: 102 Power supply overload
ERROR: 103 24 V too low
ERROR: 201(#) (Error Sewing motor see cap. 11.10)
ERROR: 202 Pattern too large
ERROR: 203 Overload data transfer sewing motor
ERROR: 204 Tacting function locked
ERROR: 205 Run function locked
ERROR: 206 No NIS
ERROR: 207 Not end of ramp
ERROR: 208 Zero point not found
ERROR: 209 Sewing function locked
ERROR: 210 Bobbin thread fault
ERROR: 211 Stitch too large
ERROR: 301 Raise clamp not completed
ERROR: 302 Lower clamp not completed
ERROR: 303 Raise clamp locked (needle position)
ERROR: 304 Lower clamp locked (needle position)
ERROR: 305 Thread wiper on locked (needle position)
ERROR: 401 Error sewing motor
ERROR: 402 Overload data transfer sewing motor
ERROR: 403 Program station not programmed
ERROR: 404 Program locked
ERROR: 405 Program does not exist
ERROR: 406 No NIS
ERROR: 407 Zero points invalid
ERROR: 408 Machine not in basic position
ERROR: 409 Zero point not found
ERROR: 410 Program too long
ERROR: 411 Incorrect program number
ERROR: 412 Incorrect number of holes in button
ERROR: 413 Coordinates of 2 holes are the same
ERROR: 414 Incorrect number of plies
ERROR: 415 Incorrect stitch formation value
To Next Page
Loading...
