Adjustment
2 - 15
Fig. 2 - 14
● Raise the presser foot.
● Turn drive eccentric 1 (screws 2) according to Requirement
..
..
.
Make sure that the cutout (see arrow) is visible.
2.16 Feeding motion of vibrating presser
Requirement
At the longest stitch length setting and with the needle bar in position 0.6 past t.d.c.
(blocking hole 1) the vibrating presser must not move when the reverse-feed control is
operated.
1
1
2
3
To Next Page
Loading...
