Fig. 9 - 02
● Place empty bobbin 1 on the bobbin winder spindle 2.
● Thread the thread as shown in Fig. 9 - 02 and wind it around the bobbin 1 a few times in a
clockwise direction.
● Switch on the winder by pushing lever 3 in the direction of the arrow, until the friction
wheel is touching the V-belt.
Bobbin 1 is filled during sewing.
● The tension of the thread on bobbin 1 can be adjusted with milled screw 4.
● The bobbin winder stops automatically, when bobbin 1 is sufficiently full.
● The quantity can be adjusted by turning screw 5.
9.02 Winding the bobbin thread / adjusting the preliminary thread tension
2
3
1
4
+
-
5
To Next Page
Loading...
