15
104 73 15-26
Settings
6. Setting the needle in centre position
NOTE!ONLY FOR AMBITION ESSENTIAL
Check 1
1. Insert a new needle size 90 universal in the machine.
2. The needle should always go its to the centre position, when the machine is turned on repeatedly.
Adjustment - needle position
1. Press the ”
“ button to ” “ mode on front cover.
2. Choose the pattern No 0 ”
“.
3. Turn the handwheel until the needle is in the center of the needle hole.
4. Remove the face plate.
5. Loosen screw (a) of needle bar driving rod pin (b). (1)
6. Adjust needle bar position by turning screw (b) clockwise or counterclockwise to get proper setting. (1)
7. Make sure needle position is in center of needle plate hole. Tighten screw (a). (1, 2)
Needle point
1
a
b
To Next Page
Loading...
Need help?
General
