9:5
Embroidery mode - stitch-out
A
B
C
D
9
Option bar
0RUHRSWLRQV
0RQRFKURPH$
Touch the icon to activate monochrome embroidery.
All designs are shown in a grey color and the
machine does not stop for color block changes. To
deactivate monochrome embroidery, touch the icon
again.
)XOOVFUHHQ%
To see your design as large as possible, use the full
VFUHHQIXQFWLRQ7KHHPEURLGHU\ZLOOÀOOWKHZKROH
screen. To close, touch the screen once.
GLPHQVLRQDOYLHZ&
Touch the 3-dimensional view icon (C) to turn on
or off a 3-dimensional view of the designs in the
HPEURLGHU\ÀHOG
By default, the designs are displayed in
GLPHQVLRQDOYLHZLQWKHHPEURLGHU\ÀHOG,Q
2-dimensional view, the designs load faster on the
screen and it is easier to see the color blocks in the
design. The view setting remains as selected even
when you turn your machine off.
6DYHFXUUHQWVWDWH'
If you want to stop embroidering and save your
current position, touch Start/Stop to stop the
embroidery. Then touch the save current state icon
to save the current position. You can now turn the
machine off.
When saving current state, all your adjustments are
stored and you can continue the embroidery later. A
current state is saved until you replace it.
Note: If you have chosen AutoSave current state in the
Settings menu, this icon will be disabled, and current
state is stored periodically.
To Next Page
Loading...
Need help?
General
