2:3
C
Preparations
3DFNDZD\DIWHUVHZLQJ
1. Turn the main switch (C) off.
2. Unplug the cord from the wall socket and then
from the machine (B).
3. Unplug the foot control cord from the machine
(A). Wind the foot control cord and place inside
the open area on the underside of the foot
control.
4. Place all accessories in the accessory tray. Slide
the tray on to the machine around the free arm.
5. Place the foot control in the space above the free
arm.
6. Put on the hard cover.
/('OLJKWV
Your machine has LED lights which distribute the
light evenly over the sewing area and eliminates
shadows.
)UHHDUP
To use the free arm, slide off the accessory tray.
When attached, a hook keeps the accessory tray
locked to the machine. Remove the tray by sliding it
to the left.
Thread cutter
To use the thread cutter, pull the thread from back
to front as shown.
Electronic knee-lift
Your machine comes with an electronic knee-lift for
regulating the presser foot height.
Insert the knee-lift in the provided hole on the
machine. Adjust the rectangular bar on the knee-lift
until it is positioned at a comfortable height for you
(C).
If you press the knee-lift to the right, the presser
foot will raise. You can now guide the fabric with
both hands.
To remove the knee-lift, just pull it straight out of
the hole.
To Next Page
Loading...
Need help?
General
