35
7 Commissioning
Before commissioning the machine, it must be thoroughly cleaned and then
oiled., see chapter 9 Care and maintenance in the instruction manual.
● Check the machine, particularly its electrical wiring and pneumatic tube
connections, for any damage.
● Have skilled personnel check if the machine can be operated with the available mains vol-
tage.
Do not operate the machine if there is any discrepancy.
The machine may only be connected to an earthed socket!
● In the case of machines with PicoDrive and P45 PD2-L control unit, have specialists
check the basic position of the machine drive before commissioning the machine (see
Chapter 7.02 Basic position of the machine drive).
7.01 Switching the machine on/off
● Switch the machine on (see Chapter 7.01, On/off switch in the instruction manual).
Commissioning
To Next Page
Loading...
