Pfeiffer Vacuum OMNISTAR - Product identification; Validity

Introduction
5
1 Introduction
1.1 Product identification
In all communications with Pfeiffer Vacuum, please specify the information on the
product name plate. For convenient reference, copy that information into the
parentheses provided below.
Figure 1-1 Product Nameplate
1.2 Validity
This document applies to products with part numbers corresponding to the following key.
See Figure 1-2.
The part number (PN) is located on the name plate.
We reserve the right to make technical changes without prior notice.
Figure 1-2 Manual Validity Key
Pfeiffer Vacuum, D-35614 Asslar
100..230V~, 50..60Hz , 550 VA
Model: (Model Number) (YYYY/MM)
PN: (Part Number)
SN: (Serial Number)
PTM 8 0 W XXX Y Z
8 OmniStar
9 ThermoStar
0 Non-corrosive and non-flammable gases
1 Corrosive or flammable gases
1 Digit code for special configurations
1 Mass range 1-100
2 Mass range 1-200
3 Mass range 1-300
3 Digit inlet module configuration code
1 sensor configuration and calibration device code