PFlow Industries F Series User Manual

 Seies | 1570-1015 | Rev  | 2022-03-01 | e-mail csd@pow.com Section  | 1
Section 9 | Sequence of Operation
www.pflow.com
P 414 352 9000
F 414 352 9002
6720 N. Teutonia Ave.
Milwaukee, WI 53209
A qualified person is defined as a person who, by possession of a recognized degree
or certificate of professional standing, or by extensive knowledge, training, and
experience, has successfully demonstrated his/her ability to solve problems relating
to the subject matter and work.
Personnel to carry out work on the VRC must exclusively be qualified personnel
who - based upon their education, experience, instructions as well as knowledge
concerning relevant standards and provisions, accident prevention, regulations
and operating conditions - have been authorized by the person being responsible
for safety, to carry out the activities described in these instructions and who - when
doing so - are in a position to recognize possible risks early and to avoid them.
Before You Begin
Read this entire manual before operating the Vertical Reciprocating Conveyor
(VRC).
Service must be performed by qualied and trained service technicians only.
NOTICE
z Stay within the rated li capacity.
z Make sure all safety devices are in place and operable before using the
equipment. If any safety device is missing or inoperable, immediately
remove the equipment from service.
z Falling hazard! Always make sure the carriage is present before walking
through doorways.
z Keep clear of unsupported platforms. Stay out of the area under a raised
platform. If a maintenance operation requires the carriage to remain in
the raised position, refer to Bulletin 15709-0083 for additional information
or contact PFlow Industries, Inc. Customer Support Department for assistance.
z This equipment can be dangerous if not used properly. Allow only
competent adults who have been properly trained and authorized
personnel to operate this equipment.
z Passengers are not permitted. Riding may result in death or serious
personal injury.
z Close all gates before the carriage is moved. Never leave the li unattended
with the gates in the open position. Never close gates when a person is on
the carriage or within the fenced area.
z Avoid Shiing Loads! Place the load in the center of the carriage platform
to avoid shiing loads. Lock rolling casters in place. Make sure that any
portion of the load does not overhang the perimeter of the carriage.
Prevent unstable load conditions.

PFlow Industries F Series Specifications

General

Brand	PFlow Industries
Model	F Series
Category	Lifting Systems
Language	English