15705-011 | Rev | 2022-03-01 | e-mail csd@pow.com Section 11 | 7
Section 11 | SEW Eurodrive Motor
Maintenance and Troubleshooting
www.pflow.com
P 414 352 9000
F 414 352 9002
6720 N. Teutonia Ave.
Milwaukee, WI 53209
Removing the
Brake
Disposal of
the Brake and
Gear Motor
The brake can only be removed aer power has been disconnected from
the VRC, the brake and motor has been de-energized, and the brake is
torque-free.
Because of the dierent material components, the components of our spring-
applied brakes and gear motors must be disposed of and recycled separately.
Follow ocial regulations.
z Iron
z Aluminum
z Copper
z Plastics
z Electronic parts
z Oil and grease (not mixed with solvents)
High Voltage! Employees servicing or maintaining VRCs may be
exposed to death or serious personal injury if hazardous energy is
not properly controlled. De-energize any circuit before work is begun.
Do not touch live components or power connections immediately
aer disconnecting the device from the voltage supply because
some capacitors may still be charged. Adhere to a minimum switch-
o time of 10 minutes. Observe the corresponding labels on the device. Follow
your facilities procedures or OSHA lockout/tagout (LOTO) procedures anytime
maintenance or service is being performed on any electrical box or component.
To Next Page
Loading...
Need help?
General