PhaseOne 645DF+ - Flash Lead Connection; Cables Shipped with IQ Back for Hasselblad H

159
Flash Lead Connection
A ash cable is always connected to the Hasselblad H1/H2 camera body.
The ash sync cable must not be connected to the camera back when
used on a Hasselblad H1/H2. The ash sync connector on the IQ back
is only intended for use with a Phase One FlexAdaptor or other large
format adaptors.
17.4 Cables Shipped with IQ back for Hasselblad H
No cables are required to use the IQ back with a Hasselblad H1/H2.
A Value Added IQ back comes with an additional multi-connector
to Lens sync cable (part# 50300143) for use with large format cam-
eras in two shot mode.
Part# 50300144 This cable is available as a separate purchase only.
From multi-connector to mini jack female (for use to adapt older Large
format wake-up cables or older Kapture Group one shot adaptor cables
to connect to the multiport).