For more information on capturing tethered with the
Phase One Capture One application please consult
the online user guide available in the Capture One Help
menu.
General Hardware Setup
The P back is designed to be used with the new me-
dium format cameras prepared for digital camera
backs.The use on these camera bodies can be done
without any cables attached between the P back and
the camera body or lens. All timing and communication
is done in the electrical interface contacts in the con-
necting plate.
Capturing images with the FlexAdaptor on large format
camera or a camera body without the digital interface
is supported by connecting the special lens sync cable
that comes with the P back. For a guide to usage on a
specific camera body, digital or not please consult the
corresponding chapters later in this manual.
Powering up the P back
When the camera back is connected to the body, and
a battery is inserted or the IEEE1394/FireWire cable
is connected. The Camera back can be turned on by
holding down the "Power" button just below the P
back display.
Indicator lights
When the camera is powered up you will see a short
blink in the green and red LED's in the right hand side
of the display and you will hear a ready beep. The
lights will turn off immediately. This is an indication that
the camera is ready to capture. In general, if no light is
on the camera is ready.
To Next Page
Loading...
Need help?
General
