Shutter latency settings
On a Phase One FlexAdaptor the P back can be used
with both Long and short latency.
Default your P back is set to Short latency, which
means that the P back will respond fast on triggering
on the cost of battery time.
This setting can be used with the Kapture Group Two
shoot adaptor.
If using the P back as a manual two shooter, where the
first shot will power up the P back, and the second will
make the exposure, you should use "Long latency".
To learn how to setup latency please consult the Menu
mode section.
The Phase One FlexAdaptor
To Next Page
Loading...
Need help?
General
