The charger has two red light indicators. While these
are on the battery is not fully charged, and should be
left in the charger until the red light starts flashing or
preferably turns off to gain a 5% extra power.
Permanent lighting LED indicates fast charge, when
the LED starts flashing the battery is practically full and
can be used. If the battery is left in the charger for as
long as the LED is still flashing, 5% extra capacity can
be gained. All charging is finished when the LED turns
off with the batteries connected.
After the first initial charge, the batteries can be
charged one at a time.
Disconnect the batteries again from the charger by
pressing the battery slightly against the unit, and at the
same time sliding the battery up and lift it off.
Warning notes!
Only use original mains adaptor 12 V DC.
Never apply excessive force when connecting the bat-
teries.
Keep all contacts clean.
Do not force down any of the contacts.
Do not short cut the contacts.
Never store the batteries in the
charger, connected to an
outlet for an extensive
period of time.
Do not expose to heat or
naked flame.
Do not dismantle or
carry out any alteration
to the product.
To Next Page
Loading...
Need help?
General
