Hasselblad 553 ELX
When using the P back on
some Hasselblad motorized
bodies (i.e. Hasselblad ELX
or Hasselblad ELM series), a
motor cable is supplied to
enable capture from the
computer.
The cable is con
-
nected between the
multi-connector on
the P back and the
DIN connector on
the Hasselblad.
Avoid using A or AS mode.
Please note that the Phase One P back should not be
mounted while the camera is set to mirror up (S or RS
modes). Also make sure that the lens is not jammed or
locked open on the “B” setting when connecting the
flash sync cable to the Phase One P back.
While using the Hasselblad 553 ELX you should set
the Shutter latency to ”Short latency”
It is possible to use "Long latency" mode on this cam
-
era when using a motor cable and only using the cap-
ture button inside the Capture One Application.
To Next Page
Loading...
Need help?
General
