14
If the SSID for the network is not
displayed, select [Other...], then press
OK to confi rm.
To enter the SSID for the network,
select an alphabet/number, then press
OK to confi rm.
To switch between uppercase
and lowercase, select [a/A] on the
displayed keypad, then press OK to
confi rm.
4 If the security key is required, enter the
security key to connect to the network.
5 When the key is complete, select [Enter],
then press OK to confi rm.
Check whether a valid IP address
is assigned to the PhotoFrame
(see ‘View system status of the
PhotoFrame’ on page 42).
•
•
•
2 Select [Installation] > [Network] >
[Wireless] > [Use manual confi guration],
then press OK to confi rm.
3 Select the SSID for the network, then press
OK to confi rm.
EN
To Next Page
Loading...
