2. The friction of the driver (1) –VI is too small. For correction see the
INSTRUCTIONS under V-2
XI THE NEEDLE TURNS THE PLATE WHEN THE P U ARM IS MOVING FROM THE OUTLET TO THE
SUPPORT ON THE SWITCH
This can only occur with 9 or 10 plates on the turntable. The cause is that the PU arm does not rise
sufficiently. In the highest position, the PU ARM must be horizontal. This can be set by the rom/BRAKE
disk
(1) with a spanner to turn counterclockwise. In this case, loosen the locking nut after a while.
R 15592
54
To Next Page
Loading...
