1-4-3 E9480FIS
Read out one or more locations in the NVRAM.
030400 Value read.
030401 Unable to initialise NVM.
030402 Reading the NVRAM contents failed.
030403 Length out of range.
030404 Unable to decode length.
030405 Offset out of range.
030406 Unable to decode offset.
030407 Unknown location specified.
030408 No location is specified.
Write to a specific memory address.
040200 Writing to the SDRAM succeeded.
040201 No address input.
040202 No data input.
040203 Address is not dividable by 4.
040204 Invalid data.
040205 Address out of range.
040206 Invalid address.
Read from a specific memory address.
040300 Reading from the SDRAM succeeded.
040301 No address input.
040302 Address is not dividable by 4.
040303 Address out of range.
040304 Invalid address.
Get the device (revision) type information of the FLASH
IC. (manufacturer and device ID)
050000 Getting the information from the FLASH succeeded.
Check whether the FLASH can be written to and read
from.
050100 The FLASH write-read test succeeded.
050101 Wrong BALO signature.
050102 Wrong CONS signature.
050103 Invalid CONS base.
050104 Invalid CONS end address.
050105 All bits in the TEST region are filled with 0.
050106 The WriteRead test failed.
050107 The Write Failed.
Read from a specific memory address.
050200 Reading the FLASH succeeded.
050201 No address input.
050202 Invalid address.
050203 Address is out of range.
050204 Address is not dividable by 2.
Check the checksum of the application partitions by
recalculating and comparing partition checksums.
050300 The checksum is valid, the test succeeded.
050301 Wrong BSTB signature.
050302 Wrong BSTB checksum.
050303 Wrong BALO signature.
050304 Wrong BALO checksum.
050305 Wrong CONS signature.
050306 Wrong CONS checksum.
050307 Invalid BALO end address.
050308 Invalid CONS base.
050309 Invalid CONS end address.
Calculate the checksum over all memory addresses.
Used to check entire FLASH contents.
050400 Calculating the checksum over all addresses succeeded.
Calculate a checksum over a selected number of
address locations.
050500 Calculating the checksum over selected addresses succeeded.
Get the device (revision) type information of the VIP IC.
060000 Getting the information from the VIP succeeded.
060001 The IIC bus initialisation failed.
060002 The communication with the VIP failed.
Check the communication between the IIC controller of
the Domino and the VIP IC.
060100 Communicating with the VIP succeeded.
060001 The IIC bus initialisation failed.
060002 The communication with the VIP failed.
Switch the clock output on.
060200 Switching the clock output on succeeded.
060201 Switching the clock output on failed.
Description Error No. Error Description
To Next Page
Loading...
