Philips ESP 2 - Macro Shooting (Close-up Shooting)

43
3
Picture-Taking Applications
DATE
Tungsten Light Mode
Use the Tungsten Light mode when shooting a picture in incandescent lighting or when
the Auto White Balance does not work properly.
q When the REC(ord)/PLAY switch is set to
REC, press the FLASH button while press-
ing the
UU
UU
U button.
w Within three seconds, press the
UU
UU
U or
TT
TT
T
button to display the
symbol on the LCD
monitor.
The will remain on the LCD monitor for about
three seconds.
Important
• The Flash Off mode is set when the Tungsten Light mode is set. At this time, the Flash mode
cannot be switched, even if the FLASH button is pressed.
• The color tone for the same subject may vary depending on the type of incandescent light.
Canceling the Mode
Press the FLASH button while pressing the U button. Within three seconds, press
the U or T button to select AUTO.