Philips VR400 - Before You Call an Engineer; Programmed recording does not work; There is picture or sound interference on TV reception; Your video recorder does not respond to any button being pressed

DWhile a programmed recording isbeing made, you
cannot operate your videorecorder manually. Ifyou
want to cancel the programmedrecording, press the
TV/STANDBYm button.
DIf the video recorder isswitched on a few minutes
before a programmed recordingis supposed to
begin, ’TIMER RECORD’ will flashon the TV
screen.
DIf you reach the end of the cassetteduring a
recording, the video recorderwill automatically
eject the cassette.
DIf you forget to load a cassette,’NO CASSETTE’
will appear on the TV screenand ’k’ will flashon the
video recorder display.
DIf you have put in a cassettewhich cannot be used
for recording, the videorecorder will automatically
eject it.
DIf ’TIMER FULL’ appears on the TV screenwhen
you press the TIMER button, you have used up all
the available TIMER blocks.If you want to clear or
check a programmed recording(TIMER block),
select it withthe P q or P r button.
DProgramme numbers ’E1’ and ’E2’ arefor
recordings from othersources (through scartsocket
EXT.1 AV 1 or EXT.2 AV 2 ).
How to check or change a programmed
recording (TIMER)
a Switch on the TV setand select the programme number
for the video recorder.
b Press the TIMER button on the remote control twice.
c Select the programmed recording(TIMER) you want to
check or change with the P q or P r button.
d Press the TIMER button.
e Select the entry field withthe D/Sr or C/Sq
button.
f Change any information withthe P r or P q button or
with the 0-9 buttons.
g Confirm with the OK button.
h Make sure that thecassette you have putin can be
recorded on. Switch offwith the TV/STANDBYm button.
DThe programmed recording will onlyfunction when
the video recorder isswitched off withthe
TV/STANDBYm button.
DThe video recorder will alwaysrecord the
programmed recording atthe speed you have
selected before the recordingstarts.
How to clear a programmed recording
(TIMER)
a Switch on the TV setand select the programme number
for the video recorder.
b Press the TIMER button on the remote control twice.
c Select the programmed recording(TIMER) you want to
clear with the P r or P q button.
d Press the CLEAR (CL), y button.
e Confirm with the OK button.
19