21
English
3.2 Connecting AC power
1 Make sure that all connections have been made
before switching on the power supply
2 Connect the AC power cord to the wall socket.
This switches on the power supply
When the Center is switched to standby mode,
they will still be consuming some power.
To disconnect the system from the power
supply completely, remove the power plug
from the wall socket.
Helpful hint:
– Always press and hold STANDBY-ON to switch
the set to power-saving mode before removing
its power plug.
The rating label of WAC3500/WAC3500D
can be found on the rear of the set.
For users in the U.K.: please follow the
instructions on page 2.
3. Installation
p1-67-wac3500_ifu_UK 2007.6.20 5:49 PM Page 21
To Next Page
Loading...
