EN7
WelcomeEye Connect 3 / V2
d. RFID badges
RFID badges can be associated with the intercom panel using the mobile application. Please refer
to the corresponding section in the manual. RFID badges can also be deleted from the mobile
application if lost.
Once linked via the mobile application, RFID badges can be used to open the electric strike plate or
gate motor drive connected to the intercom panel.
To open your electric strike plate with an associated badge, quickly swipe your badge over the RFID
read zone on the intercom panel, at the bottom right-hand edge of the intercom panel. One short
beep conrms the opening of the electric strike plate.
To open your gate motor drive with an associated badge, hold your badge in front of the RFID reader
for at least 3seconds. Two short beeps indicate that the gate is opening.
To Next Page
Loading...
