Philips WelcomeEye Connect 3 - Connecting Additional Monitors or Intercom Panels

EN37
WelcomeEye Connect 3 / V2
- Watch out for accents and characters in the names you enter, as they can prevent proper operation
if Alexa or Google Assistant are unsure of the correct pronunciation of each device.
The following controls are available:
Alexa:
- If your connected speaker has a screen: launch the intercom panel display: “Alexa, display [name
given to monitor]”.
- Turn o intercom panel display: “Alexa, stop”.
- Talk to your visitor via Alexa: “Alexa, talk to [name given to monitor]”.
- Open the gate or strike plate: “Alexa, unlock [name given to strike plate or gate opening]”.
Google Assistant:
- If your connected speaker has a screen: launch the intercom panel display: “Ok Google, display
[name given to monitor]”.
- Turn o intercom panel display: “Ok Google, stop”.
- Open the gate or strike plate: “Ok Google, unlock [name given to the strike plate or gate
opening]”.
8.4. Connecting additional monitors or intercom panels
Your videophone can be used in a single-family or two-family conguration. Single family mode is
the most traditional mode: one call button for one house with one or more monitors. The two-family
mode is useful if two houses share the same entrance, or if part of your home is being converted into
student accommodation or a rented holiday home, for example. In two-family mode, the intercom
panel has two name holders, each of which can be used to call either of the homes.
Single-family conguration:
- You can connect one or two intercom panels.
- You can connect one to three monitors.
- Each intercom panel triggers a call to all the monitors in the house.
- You can call each monitor from another monitor.
Two-family conguration:
- You can connect one or two intercom panels.
- You can connect one to three monitors per family, i.e. a maximum of six monitors in total
on the installation.
- The call button (bell icon) on the intercom panel is replaced with a second name holder
(supplied) to identify and call either of the two families. In two-family mode, the top button
corresponds with family 1 and the bottom button with family 2
- Each intercom panel can be used to call either of the two families.
- Within a family, you can call each monitor from another monitor.
Warning:
- Wiring each element of the installation is not enough: there is a conguration stage to follow so
that each intercom panel and monitor is aware of all the elements in the installation.
- Following each conguration, the entire installation must be restarted: all the monitors must
be disconnected from their power supply simultaneously to implement the changes made to the
wiring.
- For correct operation in two-family mode, the entire installation must be powered up. If there is a
power cut in family 1, family 2 will no longer receive any calls either.