Philips WelcomeEye Connect 3 - Monitor Interface; Main Menu

EN11
WelcomeEye Connect 3 / V2
10 - Connect the two wires from the monitor and, if necessary, connect the electric strike plate and
the gate (see section 1. Wiring).
11- Reposition the silicone cover on the connection terminal blocks.
12- Put the front of the intercom panel back on. Make sure you put the top of the front panel on rst
so that it hooks onto the top lug of the intercom panel.
13- Tighten the tamper-resistant screw underneath the intercom panel, using the tool provided.
When screwed in, the screw comes out and locks the front panel.
14- You can now power on the system monitor(s). When the power is switched on, the Philips logo
appears on the monitor(s).
15- Press the intercom panel call button to initiate a call and complete the conguration of your
installation.
6. MONITOR INTERFACE
6.1. Main menu
Flick the screen to switch on and access the home screen (date and time display). Then click on the
screen to display the main menu.
10/04/202411:19
Live view History
Intercom
Phone call
Settings
A
B
C
D
E
A. Monitoring function
B. Photo and video album
C. Intercom function between monitors (requires the presence of several monitors on the installation)
D. Emergency call function
E. Settings
: indicates that there is no SD card in the device.
Note: the SD card is optional; the monitor has on-board memory for storing photos and videos.
: indicates that the product is connected to the WiFi network and the Internet.
: indicates that the chime is active: pressing the intercom panel’s call button will cause the
chime to be emitted.
Note: you can browse through the menus and return to the previous menu at any time using the
icon at the top left of each screen.