Philips WelcomeEye Connect 3 - Page 24

EN20
WelcomeEye Connect 3 / V2
8
WiFi
10/04/202411:19
Wi
Tranfer to mobile
Informations
The “Transfer to mobile” cursor is used to set a delay between the chime on the monitor and that on
the mobile applications. This gives the occupants in the house time to answer before the call rings
out on their smartphones. You can set it from 0 to 20s.
On this page, you can connect your monitor to your WiFi network by clicking on “Information”:
10/04/202411:19
Wi informations
Network
Waiting
Click on “Add network”: the list to the right of the screen will show the WiFi networks within range
of the monitor. Select one of them, enter its password and click on “Conrm”.
After a few moments, the monitor shows that it is connected to the WiFi network and the Internet.
A QR code appears at the bottom right of the screen: you can use it to set up your system using the
Philips Door Connect application.