www.phocos.com 26 | P a g e
01
AC output source priority:
Configure the p riority of
whic h power s ources supply
the AC output load
Utility / AC input first (Default)
“USB”for:
Utility → Solar → Battery
AC input / utility will provide power
to the loads as first priority. If there
is excess solar power beyond what
is required for battery charging,
this power is used to supplypower
to the loads instead. The battery is
not discharged (Grid mode).
Solar and battery will provide
power to the loads when AC input /
utility power is unavailable (O ff-
Grid mode).
Solar / PV first
“SUB”for:
Solar → Utility → Battery
Solar provid es power to the loads
as first priority. If solar power is not
sufficient to power all connected
loads, AC input / utility power will
supply the loads simultaneously
(Grid mode).
If no solar power is available (ex. at
night), AC input / utility power is
used exclusively. The battery is only
disc harged whenthe AC input /
utility power is unavailable (Off-
Grid mode).
SBU priority
“SBU”for:
Solar → Battery → Utility
Solar powers the loads as first
priority. If solar power is not
sufficient to power all connected
loads, the batter y will supply power
to the loads at the same time. The
Any-Grid is disconnected from the
grid at this time (Off-Gr id mode).
AC input / utility provides power to
the loads ( Grid mode) only when
the battery voltage drops to either
low-level warning voltage or the
setting point in settings menu 12.
When first applying SBU priority,it
may take up to 10 minutes for the
Any-Grid to switch to Off-Grid
mode.
02
Maximum total battery
charging current of AC and
solar charging combined:
Max. total c harging current =
AC input charging current +
solar charging current
This setting is impor tant t o
limit charging current for
some batter
To Next Page
Loading...
