To Next PageTo Next Page
Need help?Do you have a question about the Phoenix Contact ELR W3 500AC I Series and is the answer not in the manual?
General| Type | Solid-state relay |
|---|---|
| Rated Control Supply Voltage | 24 V DC |
| Connection Method | Screw connection |
| Width | 22.5 mm |
| Operating frequency | 50/60 Hz |
| Protection class | IP20 |
| Rated Operating Voltage | 48 V AC ... 500 V AC |
| Operating temperature range | -25 °C to 60 °C |
| Storage temperature range | -40 °C to +85 °C |
| Relative humidity | 95% (non-condensing) |
| Standards | IEC 60947-4-3 |
| Input voltage | 24 V DC |
| Output voltage | 48 V AC ... 500 V AC |
| Output current | 0.15 A ... 50 A (See derating curve) |
| Input voltage range | 19.2 - 30 V DC |
| Input frequency range | 47 - 63 Hz |
| Switching Mode | Zero voltage switch |
Details on mains connection and necessary line protection for the device.
Schematic representation of the internal components and connections of the device.
Explanation of the LED indicators for device status and operation.
Details on the device's diagnostic capabilities and error detection.
Methods for acknowledging and resetting errors on the hybrid motor starter.
Information on the device's feedback signals and their meaning.
Guide to setting the nominal current and parameterizing the device.
Example circuit for integrating the starter into an EMERGENCY STOP chain.
Circuit example for safety door applications using the motor starter.
Explanation of the motor overload protection function of the hybrid motor starter.
Guidelines for connecting and configuring a motor with a brake.
Instructions for connecting auxiliary relays for external brakes or PLCs.
