27
Maintenance
The system continuously monitors approximate remaining life of cartridges, UV lamp and
Ultrafilter. Current consumable condition and water resistivity is displayed on the HOME SCREEN.
A Maintenance Log is provided in the software. If preferred, a Maintenance Log template is
provided as an addendum that can be copied for future use, printed and distributed as required.
Sample software maintenance log
ALL MODELS:
Cartridge life is determined by a combination of elapsed time since installation and water
resistivity. The point at which the conditioning pack and polishing filter transition from green
health status to yellow can be adjusted. See the next section for adjustment instructions.
See the table below for default health meter resistivity settings:
Between 2 MegΩ and 12 MegΩ
< 2 MegΩ (default alarm set point)
Between 10 MegΩ and 16 MegΩ
< 10 MegΩ (default alarm set point)
*If set point is adjusted, (see Resistivity Alarm Setup), yellow health meter color will appear at the
new set point.
Typical conditioning and polishing cartridge life is estimated at 4 - 6 months from date of
installation depending on usage. After six months a cartridge replacement alarm will be displayed.
It is the user’s prerogative to replace cartridges bearing in mind the currently displayed water
resistivity may still be acceptable. It is highly recommended cartridges be replaced at six months to
prevent biofilm generation that may occur over time.
To Next Page
Loading...
Need help?
General
