- Using a 19 mm hexagonal spanner, extract the
roller bearing.
Specific tooling
020458Y Puller for lower bearing on steering
tube
- Insert the a new plate and a new dust guard in
the steering tube
- Insert a new roller bearing in the roller tube.
- Using the special tool and a mallet to move the
dust guard and the bearing in abutment.
Specific tooling
006029Y Punch for fitting fifth wheel seat on
steering tube
- With the 10 mm hexagonal wrench for internal
parts loosen the upper stem closing cap.
- Loosen the stem support clamp and remove fork
leg and stem.
Suspensions Carnaby 125 - 200
SUSP - 202
To Next Page