Pilz PNOZmulti User Manual

Installation
Installation Manual PNOZmulti Installation Manual
1002265-EN-02
19
4.3 Install the control system PNOZmulti Mini
4.3.1 Install base unit without expansion module
Make sure that the terminators are inserted on the top left and right of the unit :
} Left: Black/yellow terminator
} Right: Yellow terminator
Left:
Black/yellow
terminator
Right:
Yellow
terminator

Pilz PNOZmulti Specifications

General

PL	PL e
Expansion Modules	Yes, via base units and extension modules
Programming	PNOZmulti Configurator (graphical configuration software)
Safety standards	EN ISO 13849-1, EN 62061, IEC 61508
SIL	SIL 3
Operating voltage	24V DC (typically, but can vary depending on the specific module)
Safety category	Category 4