After Installing this
Navigation System
1 Reconnecting the battery.
First, double-check that all connections are
correct and that this product is installed cor-
rectly. Reassemble all vehicle components
that you previously removed. Then reconnect
the negative (–) cable to the negative (–) term-
inal of the battery.
2 Start the engine.
3 Press the RESET button.
Press the RESET button on the display unit
using a pointed object such as the tip of a
pen.
4 Enter the following settings:
1 Install the program in the navigation sys-
tem.
2 Set the time and language.
3 Drive until the initialized sensors start oper-
ating normally.
Set the navigation system as explained in the
Operation Manual.
Note
After installing this navigation system, be sure to
check at a safe place that the vehicle is perform-
ing normally.
After Installation
En
31
English
Section
05
To Next Page
Loading...
