Pioneer PDP-436SXE - Page 82

PDP-436SXE
82
1234
1234
C
D
F
A
B
E
No. Function/Display
SG Pattern (Brightness
IRE Level/Color)
No. Function/Display
SG Pattern (Brightness
IRE Level/Color)
1 COLOR BAR1 Colorbar(75%) 11 RASTER4 Raster(75% Green)
2 COLOR BAR2 Colorbar(100%) 12 RASTER5 Raster(75% Magenta)
3 RAMP1 Ramp(100% white) 13 RASTER6 Raster(75% Red)
4 RAMP2 Ramp(100% Yellow) 14 RASTER7 Raster(75% Blue)
5 RAMP3 Ramp(75% Green) 15 RASTER8 Raster(-% Black)
6 RAMP4 Ramp(75% Red) 16 10STEP1 10STEP(100% white)
7 RAMP5 Ramp(75% Blue) 17 10STEP2 10STEP(100% Yellow)
8 RASTER1 Raster(100% White) 18 10STEP3 10STEP(75% Green)
9 RASTER2 Raster(75% Yellow) 19 10STEP4 10STEP(75% Red)
10 RASTER3 Raster(75% Cyanide) 20 10STEP5 10STEP(75% Blue)
1
123456789
10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
I N I T I
S I D E MA S K L E V E L ( +)
EA L I Z – 1 1V D 1 6 0 1 – N T V – J H S 6
4. SIDE MASK LEVEL
Important notice of the Test Signal mode (SG mode, SG pattern)
• The route switching should be done correctly in the factory mode.
• Y or G signal from SG should be input to the AVI terminal of the MVDEC when the SG signal is output.
• The function of the blanking offset (50 IRE) should be OFF during the SG mode.
• The setting of the Y/C separation function should be set to the NTSC during the SG mode
• Only the RGB and Component signals can be output during SG mode, so only the Y signal is input at the CVBS and S
signal mode, thus the picture is composed in black and white color. This isn't a trouble.
• The SG mode 5 (ANA AD RGB) is only for the factory mode. Therefore some probrem (strange color, unstable brightness
etc.) might be happened.
Level of the side mask (R, G, and B) can be adjusted by using this menu.
The input signal is necessary to adjust it.
No. Display
Context
1R MASK LEVEL ⇔
Adjust Side Mask R (range :000-255)
2G MASK LEVEL ⇔
Adjust Side Mask G (range :000-255)
RS-232C
RSL
GSL
3B MASK LEVEL ⇔
Adjust Side Mask B (range :000-255)
BSL
1
123456789 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
I N I T I
S G P C O L O R B A R 1A T T E R N < = >
EA L I Z – 1 1V D 1 6 0 1 – N T V – J H S 6
3. SG PATTERN