23
En
03
Chapter 3
Getting Started
Making settings
using the Setup
Navigator menu
Be sure to perform these settings when using the
player in the following situations.
• When you use the player for the first time.
•After Initial Setup format.
Caution
• Before turning on the power, check that the
connections between the player and other
devices are correct. Also, turn on the power of
the devices connected to the player before
turning on the player’s power.
• When using a TV or front projector compatible
with the Control function, set Control to On on
the connected device before turning on the
player’s power.
1 Turn on the TV’s power and switch the input.
See the TV’s operating instructions for the details
of operating the TV.
2 Turn on the player’s power.
Press ^ STANDBY/ON.
Check that the Setup Navigator menu is displayed.
❖ If the Setup Navigator menu is not
displayed
Press HOME MENU to display the Home
Menu, select Initial Setup
Setup Navigator Start,
then press ENTER.
3 Start Setup Navigator.
Press ENTER.
• Setup Navigator starts.
4 Select the OSD language.
Use / to select, then press ENTER.
5 Select the appropriate output resolution for the
connected TV.
Use / to select, then press ENTER.
6 Select the appropriate aspect ratio for the
connected TV.
Use / to select, then press ENTER.
7 Close the Setup Navigator menu.
Press ENTER.
• Setup Navigator finishes and the setting is
stored.
• Press RETURN to go back to the previous
screen.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
