LIST OF ILLUSTRATIONS (cont)
FIGURE NO. SUBJECT GRID NO.
74-12. Assembly Tool 3D21
74-13. Assembly Tool Application 3D22
74-14. Measuring Lead Assembly Length 3D23
74-15. Ferrule Seating Tool 3D24
74-16. Measuring Wire From Top of Ferrule 3D24
74-17. Needle 3D24
74-18. Installing Grommet Over Lead Assemblies 3D24
74-19. Lead Assembly Installed in Grommet 3E2
74-20. Wire Doubled Over For Installation of Eyelet 3E2
74-21. Ignition Schematic 3E3
74-22. Removing Frozen Spark Plug 3E5
74-23. Contact Points 3E9
74-24. Rotor Holding Tool Installed 3E10
74-25. Timing Kit Installed 3E10
74-26. Aligning Timing Marks 3E10
74-27. Checking Flyweight Clearance of Impulse Coupling 3E10
74-28. Engine Timing Marks 3E13
74-29. Magneto Adjustment Limits 3E13
74-30. Magneto Timing Marks 3E14
74-31. Removing Spring From Lead Assembly 3E15
74-32. Assembly Tool 3E16
74-33. Using Assembly Tool 3E16
74-34. Measuring Lead Assembly Length 3E17
74-35. Cutting Metallic Braid From End of Lead 3E17
74-36. Unbraiding Metallic Shielding 3E17
74-37. Forming Shielding Around Ferrule 3E19
74-38. Ferrule Seating Tool 3E19
74-39. Needle 3E19
74-40. Measuring Wire From Top of Ferrule 3E21
74-41. Installing Grommet Over Lead Assemblies 3E21
74-42. Lead Assembly Installed in Grommet 3E21
74-43. Wire Doubled Over For Installation of Eyelet 3E21
74-44. Removing Spark Plug Frozen to Bushing 3E22
74-45. Ignition Switch Wire Positions 3F1
78-1. Exhaust System Inspection Points 3G4
80-1. Exploded View of Gear Reduction Starting Motor 3G15
80-2. Turning Starting Motor Commutator 3G17
80-3. Testing Motor Armature for Shorts 3G17
80-4. Testing Motor Fields for Grounds 3G17
80-5 No-Load Test Hook-Up 3G19
80-6. Stall-Torque Hook-Up 3G19
81-1. Schematic Diagram of Turbocharger System 3H4
Introduction
Page - 13
Revised: July 13, 1983
1A14
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL
To Next Page
Loading...
Need help?
General
