27-00-02
Page 27-04
Revised: February 23, 1979
1J23
CHART 2701. TROUBLESHOOTING (SURFACE CONTROLS) (cont)
Excessive resistance to rud- Cables not in place on Install cables correctly. Check
der pedal movement. (cont) pulleys. cable guards.
Cables crossed or routed Check routing of control
incorrectly. cables.
Rudder pedals not neutral Rudder cables incorrectly Rerig rudder cables or
when rudder is streamlined. rigged or nose gear rods nose gear rods.
incorrectly rigged.
Incorrect rudder travel. Rudder sector stop in- Rerig sector stops.
correctly adjusted.
Pedal contacts secondary Reposition rudder pedal to
stop before rudder. neutral position or rudder
trim or nose gear rods and
rerig either.
Trim control knob moves System not lubricated Lubricate system.
with excessive resistance. properly.
Lost motion between con- Cable tension too low. Adjust cable tension.
trol wheel and stabilator.
Linkage loose or worn. Check linkage and tighten
or replace.
Broken pulley. Replace pulley.
Cables not in place on Install cables correctly.
pulleys.
Resistance to stabilator System not lubricated Lubricate system.
control movement. properly.
Cable tension too high. Adjust cable tension.
Binding control column. Adjust and lubricate.
Trouble Cause Remedy
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL
RUDDER CONTROL SYSTEMS (cont)
STABILATOR CONTROL SYSTEM
RUDDER TRIM CONTROL SYSTEM
To Next Page
Loading...
Need help?
General
