Piper PA-32RT-300T User Manual

LANCE
II SERVICE
MANUAL
4-22. LIQUID
SAFETY
WALK
REPAIR.
4-23.
SURFACE PREPARATION
FOR LIQUID
SAFETYWALK.
a Clean
all surfaces
with
a suitable
cleaning
solvent
to remove
dirt,
grease and
oils.
Solvents
may be applied
by dipping,
spraying
or mopping.
b.
Insure that
no moisture
remains on
the surface
by wiping with
a clean
dry cloth.
c. Outline
the area
to which
the liquid
safety walk
compound is
to be applied,
and
mask adjacent surfaces.
NOTE
Newly painted
surfaces
shall
be allowed
to dry for
2.5 hours
mimimum
prior
to
the application
of the safety
walk.
4-24. PRODUCT
LISTING
FOR LIQUID
SAFETY WALK
COMPOUND.
a Suggested
Solvents:
Safety solvent per MIL-S 18718
Sherwin Williams
Lacquer Thinner R7KC120
Glidden Thinner No. 207
b. Safety Walk Material:
Walkway
Compound and Matting, Nonslip
(included in Piper Kit No.
179 872)
4-25. APPLICATION
OF
LIQUID
SAFETY WALK
COMPOUND.
Liquid
safety walk
compound
shall be applied
in an area
free of moisture
for a period
of 24
hours minimum
after application.
Do
not apply
when surface
to be coated
is below
50
0
F. Apply
liquid as
follows:
a.
Mix and
thin the
liquid safety
walk compound
in
accordance
with the
manufacturer's
instructions
on the container.
b. Coat
the specified
surfaces with
a smooth,
unbroken
film of the
liquid safety
walk
compound.
A nap type
roller or
a stiff bristle
brush is recommended
using fore and
aft
strokes.
c. Allow the
coating to
dry for 15
minutes to one
hour before
recoating
or touch-up,
if
required after
application of the
initial coating.
d. After recoating
or touch-up,
if done, allow the
coating to dry for
15 minutes to one
hour before removing masking.
NOTE
The coated
surface shall
not be walked
on for
six hours
minimum
after application
of final coating.
Revised:
9/2/78
STRUCTURE
1F3

Piper PA-32RT-300T Specifications

General

Brand	Piper
Model	PA-32RT-300T
Category	Aircrafts
Language	English