Piper PA-32RT-300T User Manual

845
Figure
2-6.
Jacking
Arrangement
2-9.
STEP, HANDHOLD,
AND
WALKWAYS.
A fixed
handhold
is located
on the
right side
of
the fuselage,
above
and
aft of
the center
seat
window.
The
walkway
is made
up
of a
non-skid
compound
applied
to the
wing surface
(Refer
to
Section
IV for
repair).
A step
is
available
as optional
equipment
and is
installed
just
aft of the
trailing
edge
of the right
flap.
2-10. GROUND
HANDLING.
2-11.
GENERAL.
Ground
handling
covers
all essential
information
governing
the
handling
of the
airplane
on
the ground.
This
includes
jacking,
weighing,
leveling,
mooring,
parking,
towing
and taxiing
When
the airplane
is handled
in
the manner
described
in
the following
paragraphs,
damage
to the airplane
and its
equipment
will
be prevented.
2-12. JACKING.
Jack
the airplane
to
service
the landing
gear
and
as specified
to
perform
other
service operations.
Proceed
as follows:
a. Place
the
jacks
under
jack pads
on
the front
wing
spar.
(Refer
to Figure
2-6.)
b.
Attach
the
tail support
to the
tail
skid.
Place
approximately
300
pounds
of
ballast
on the
base of
the tail
support
to hold
down
the tail.
CAUTION
Be
sure
to apply
sufficient
tail support
ballast;
otherwise
the
airplane
will tip forward.
c. Raise
the
jacks
until
all
three
wheels
are
clear
of the
surface.
LANCE
II SERVICE
MANUAL
Issued:
1/3/78
1B21
HANDLING
AND SERVICING

Piper PA-32RT-300T Specifications

General

Brand	Piper
Model	PA-32RT-300T
Category	Aircrafts
Language	English