4. Unscrew the moistener bottle cap and fill it with Pitney Bowes E-Z Seal®. Do not overfill the
moistener bottle.
5. Screw the cap back on and place the bottle back in its original site (upside down in the device).
6. Close the feeder access cover.
7. If the tank is empty, allow 30 minutes for the moistener brush and wick to get completely wet.
Feeding envelopes
Your SendPro C Auto can automatically feed a stack of envelopes.
Before you begin
l
All envelopes in a single stack must be the same width and thickness.
l
All envelopes in a single stack must be sealed or unsealed. Mixing sealed and unsealed
envelopes in a stack will cause a jam in the moistener.
Maintenance
Pitney Bowes Operator Guide July 2023 191
To Next Page
Loading...
