Pixsys ATR144 - Page 47

User manual - ATR144- 47
2 d .P. 1 Decimal Point 1
Select number of displayed decimal points for AI1
0 Default
0.0 1 decimal
0.0 0 2 decimals
0.000 3 decimals
3 d e G r. Degree
°C Celsius degree (Default)
°F Fahrenheit degree
K Kelvin degree
4 L.L.i .1 Lower Linear Input AI1
AI1 lower limit only for linear signals. Ex.: with input
4..20 mA this parameter takes value associated to 4 mA.
The value may be greater than the one entered on the
next parameter.
Lower limit for termination, in case of process
transmission in modbus master.
-9999..+30000 [digit
1 p. 86
] Default: 0.
5 u .L.i .1 Upper Linear Input AI1
AI1 upper limit only for linear signals Ex: with input
4..20 mA this parameter takes value associated to 20
mA.The value may be lower than the one entered on
the previous parameter.
Upper limit for termination, in case of process
transmission in modbus master.
-9999..+30000 [digit
1 p. 86
] Default:1000
6 P. v A .1 Potentiometer Value AI1
Selects the value of the potentiometer connected on
AI1
1..150 kohm. Default: 10kohm